Section 1
Service Overview
1-1. Checking before Installation
1-1-1. Checking the ROM and Software Version
When connecting the peripheral equipment in the list below to this unit, be sure to check that the ROM and software
version on each peripheral device is corresponding to the camera to be connected.
If the ROM and software version is lower than the specified below, be sure to perform ROM replacement and updating
the software.
If ROM replacement and updating the software are required, contact your local Sony Sales Office/Service Center.
ROM
Peripheral Equip-
ment
Board Name Ref. No. ROM Version
CNU-700 AT-89 board or AT-89A board IC4, IC5 Ver. 1.30 and higher
Software
Peripheral Equipment Board Name Software Version
RCP-920/921 MPU-143 board Ver. 1.11 and higher
RCP-1000/1001 MPU-152 board Ver. 2.50 and higher
RCP-1500/1501/1530 MPU-153 board Ver. 2.50 and higher
HDCU2000/2500 AT-167A board Ver. 2.21 and higher
MSU-900/950 CPU-396 board Ver. 1.21 and higher
MSU-1000 MPU-150 board Ver. 2.50 and higher
MSU-1500 MPU-151 board Ver. 2.50 and higher
BPU4000 AT-189 board Ver. 3.00 and higher
HDC4300
1-1
To Next Page
Loading...
