Stephan EVETR - Energy Supply Connection

®
5 Preparation for use
 Fritz Stephan GmbH
GA-070T-0518V2.7-HAO-EN
113
5.2 Energy supply connection
NOTE
The device, including its external power supply, must be positioned so that it can be
disconnected from the mains power at all times.
5.2.1 Mains power supply
Connect the power supply to the corresponding socket (see chapter 3.6)
on the back of the EVE
TR
. Connect the power supply cable of the power
supply unit to the mains (80 – 240 V) and switch on the power supply
unit.
WARNING
According to IEC 60601-1-1, the energy supply must only be connected to energy
supply grids with adequate protective conductor connection.
WARNING
The power supply is part of the system. Only use original power supplies from FRITZ
STEPHAN GMBH, otherwise damage to the EVE
TR
may result.
5.2.2 12/24 V mains power supply
The EVE
TR
can be operated directly at 12 V or 24 V using the
ambulance or helicopter bracket. Connect the power plug to the 12/24 V
socket on the back of the corresponding ambulance bracket (see
chapters 3.7.1 and 3.7.2).
Power supply operation