The information contained in this document is confidential, and only for the information of the intended recipient and may not be published or redistributed without the prior written consent of Summa NV.
Summa nv Tel +32 59 27 00 11 Fax +32 59 27 00 63 Email support@summa.com Website www.summa.com Page 54 of 76
▪ There may be a bowing on the printout:
▪ When cutting with the OPOS-X alignment method, the bowing of the print is not
compensated:
▪ By using the OPOS-XY alignment method, the bowing will be compensated:
▪ In case the bowing of the print is not constant over the length of the job, then only the
first part of the job may be correctly compensated for the bowing:
To Next Page
Loading...
