3-16
ENGINE
•
Remove
the
key
<D
.
balance
r drive
gea
r
(2)
and
pin
.
• Hold the generat
or
ro
tor using a 27-mm offset wrench, and
then
re
move the generator rotor nut.
• Remove the generator rotor using the special tool.
£tEl
09930-31921:
Rotor
remover
NOTE:
Temporarily install the generator rotor nut
to
the crankshaft, and
then remove the generator rotor using the special tool.
[CAUTION [
Do
not
hit
the generator r
otor
with
a
hammer
, otherwise
the rotor may be damaged.
• Remove the generator
ro
t
or
key @.
• Remove the starter driven gear @.
To Next Page
Loading...
