GEARSHIFTING 9-6
• Apply a small quantity of THREAD LOCK to the gearshift cam
driven pin
6 and tighten it to the specified torque.
% 99000-32050: THREAD LOCK “1342” or equivalent
$ Gearshift cam driven pin: 24 N·m (2.4 kgf-m, 17.5 lb-ft)
• Fit the springs
7, pins
8, pawls
9 and gearshift roller
0 to
the gearshift cam driven gear
A.
NOTE:
Wider side
C of pawl should be positioned outside.
• With the pawls held in pushed position, install the pawl lifter
B.
• Install the gearshift cam driven gear and pawl lifter.
• Apply THREAD LOCK SUPER to the screws and tighten
them to the specified torque.
# 99000-32030: THREAD LOCK SUPER “1303”
or equivalent
$ Pawl lifter screw: 8.5 N·m (0.85 kgf-m, 6.0 lb-ft)
To Next Page
Loading...
