2-18 PERIODIC MAINTENANCE
HOT STARTER
Adjust the hot starter cable play as follows:
NOTE:
Be careful not to damage the lever cover when installing.
(!20-24)
• Loosen the lock-nut
1.
• Turn adjuster
2 so the hot starter lever clearance
A mea-
sured at the lever holder obtains 2 – 3 mm (0.08 – 0.12 in)
when squeezing the lever until pressure is felt.
• Tighten the lock-nut
1.
# Hot starter lever clearance
A: 2 – 3 mm (0.08 – 0.12 in)
$ Cable adjuster lock-nut: 2.2 N·m (0.22 kgf-m,1.60 lb-ft)
• Check that the hot starter lever moves smoothly from full open
to full close.
• If it does not move smoothly, lubricate the hot starter cable.
To Next Page
Loading...
