5-2 ENGINE REMOVAL AND INSTALLATION
ENGINE REMOVAL AND INSTALLATION
REMOVAL
• Drain engine oil. (!2-11)
• Drain engine coolant. (!14-3)
• Remove the seat
1.
• Remove the radiator covers
2, left and right.
• Remove the right frame cover
3.
• Place the jack under the frame to support the motorcycle.
• Remove the fuel tank bolt and rubber band.
• Lift and hold the fuel tank.
• Disconnect the fuel pump coupler
4.
• Place a rag under the fuel hose
5 and disconnect the fuel
hose
5 from the fuel pump.
• Remove the fuel tank assembly.
" WARNING
To prevent the motorcycle from falling, make sure to
support the frame with a jack.
CAUTION
Be sure to disconnect the fuel hose
5 by your hand.
You may not disconnect the fuel hose
5 with any tool.
When removing the fuel tank, do not leave the fuel
hose
5 on the fuel tank side.
To Next Page
Loading...
