Suzuki RM-Z450 - Conrod Inspection; Crankshaft Inspcection; Oil Reed Valve Inspection; Crankshaft Runout

10-7 TRANSMISSION AND CRANKSHAFT
• Measure the gearshift fork groove width with a vernier cali-
pers.
# Gearshift fork groove width
Standard: 5.0 – 5.1 mm (0.197 – 0.201 in)
" 09900-20101: Vernier calipers
CONROD INSPECTION
• For conrod inspection other than the following, refer to page
6-22.
• Measure the conrod deflection with the special tools.
# Conrod deflection
Service Limit: 3.0 mm (0.12 in)
" 09900-20607: Dial gauge (1/100, 10 mm)
09900-20701: Magnetic stand
09900-21304: V-block
CRANKSHAFT INSPCECTION
• Measure the crankshaft runout with V-blocks and dial gauge.
NOTE:
Place the crankshaft onto the V-blocks so that it becomes hori-
zontally.
# Crankshaft runout
Service Limit: 0.08 mm (0.0031 in)
" 09900-20607: Dial gauge (1/100, 10 mm)
09900-20701: Magnetic stand
09900-21304: V-block
• Measure the crankshaft web to web width with a vernier cali-
pers.
# Crank web to web width
Standard: 61.9 – 62.1 mm (2.437 – 2.445 in)
" 09900-20101: Vernier calipers
OIL REED VALVE INSPECTION
(!11-3)