7-6 CLUTCH
PUSH ROD
• Inspect the push rod for wear and damage.
• If any defects are found, replace the push rod with a new one.
RELEASE BEARING
• Inspect the clutch release bearing for any abnormality, partic-
ularly cracks, to decide whether it can be reused or should be
replaced.
• Smooth engagement and disengagement of the clutch
depends on the condition of this bearing.
INSTALLATION
Install the clutch plates in the reverse order of removal. Pay
attention to the following points:
• Install the spring washer seat
1 and spring washer
2 onto
the clutch sleeve hub correctly.
• Apply engine oil to the drive plates
3 and driven plates
4.
• Install the clutch drive plates and driven plates one by one
into the clutch sleeve hub in the prescribed order as show in
illustration.
Direction of outside
Drive No.1 plate A
Drive No.2 plate B
C
Driven No.1 plate C
Driven No.2 plate D
Clutch facing a
36 pcs.
48 pcs.
Color
Silver
Gray
To Next Page
Loading...
