10-13 TRANSMISSION AND CRANKSHAFT
TRANSMISSION INSTALLATION
NOTE:
Install the snap ring in the groove and locate its end as shown in
the illustration.
• Apply engine oil to the following parts: driveshaft, countershaft,
transmission gears, bearings.
• Install the driveshaft
1 and countershaft
2 with gears
installed.
NOTE:
* Install the washers
A,
B located in both ends of the driveshaft
positively.
* Install the washer
C located in end of the countershaft
2 pos-
itively
CAUTION
The removed snap ring should be discard.
Sharp edge
Thrust
To Next Page
Loading...
