ELECTRICAL SYSTEM 15-4
USING THE MULTI-CIRCUIT TESTER
• Properly use the multi-circuit tester
+ and
- probes.
Improper use can cause damage to the motorcycle and
tester.
• If the voltage and current values are not known, begin mea-
suring in the highest range.
• When measuring the resistance, make sure that no voltage is
applied. If voltage is applied, the tester will be damaged.
• After using the tester, be sure to turn the switch to the OFF.
" 09900-25008: Multi-circuit tester set
NOTE:
* When connecting the multi-circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
* Use the needle pointed probe to prevent the rubber of the
water proof coupler from damage.
"09900-25009: Needle pointed probe set
CAUTION
Before using the multi-circuit tester, read its instruc-
tion manual.
To Next Page
Loading...
