Suzuki RM-Z450 - Iap Sensor Inspection; Iap Sensor Removal and Installation; Tp Sensor Inspection; Tp Sensor Removal and Installation

FI SYSTEM DIAGNOSIS 12-46
SENSORS
CKP SENSOR/CRANKSHAFT ROTATION
SIGNAL SENSOR INSPECTION
The CKP sensor

1 and crankshaft rotation signal sensor

2 are
installed at the inside of the magneto cover. ("12-25, -44)
CKP SENSOR/CRANKSHAFT ROTATION
SIGNAL SENSOR REMOVAL AND INSTAL-
LATION
• Remove the magneto cover. ("15-17)
• Remove the CKP sensor and crankshaft rotation signal sen-
sor. ("15-19)
• Install the CKP sensor and crankshaft rotation signal sensor
in the reverse order of removal.
IAP SENSOR INSPECTION
The IAP sensor is installed on the throttle body. ("12-31)
IAP SENSOR REMOVAL AND INSTALLATION
• Remove the fuel tank. ("13-2)
• Remove the IAP sensor from the throttle body. ("13-10)
• Install the IAP sensor in the reverse order of removal.
TP SENSOR INSPECTION
The TP sensor is installed at the left side of the throttle body.
("12-27)
TP SENSOR REMOVAL AND INSTALLATION
• Remove the engine mounting upper bracket (LH). ("5-5)
• Remove the TP sensor. ("13-9)
• Install the TP sensor in the reverse order of removal.
• Adjust the TP sensor. ("12-18)