Suzuki RM-Z450 - Stator; Removal; Installation

15-19 ELECTRICAL SYSTEM
• Install the dowel pins and gasket

2.
• Install the magneto cover

3 and magneto cover guard

4.
NOTE:
Fit the clamp to the bolt

B.
+ Magneto cover bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Install the gearshift lever. (!9-7)
• Pour engine oil. (!2-11)
STATOR
REMOVAL
• Remove the magneto cover. (!15-17)
• Remove the clamp

1.
• Remove the CKP sensor

2 along with stator

3.
INSTALLATION
• Install the stator, CKP sensor and clamp.
NOTE:
Be sure the grommet is set to the magneto cover.
• Tighten the stator bolts and CKP sensor bolts to the specified
torque.
+ Magneto stator bolt: 5.5 N·m (0.55 kgf-m, 4.0 lb-ft)
CKP sensor bolt: 5.5 N·m (0.55 kgf-m, 4.0 lb-ft)
• Install the magneto cover. (!above)
CAUTION
Replace the gasket

2 with a new one.
CAUTION
Fit the new gasket washer to the bolt

A.