2-12 PERIODIC MAINTENANCE
ENGINE OIL FILTER CHANGE
• Drain the engine oil as described in the engine oil replace-
ment procedure.
• Remove the oil filter cap
1 and spring
2 with oil filter
3.
• Apply engine oil lightly to the gasket of the new oil filter before
installation.
• Install a new oil filter.
• Apply engine oil lightly to the new O-ring.
• Install the oil filter cap and tighten the bolts.
$ Oil filter cap bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Add new engine oil and check the oil level as described in the
engine oil level inspection procedure.
# Oil change.......... 1 050 ml (1.1/0.9 US/Imp qt)
Filter change ......1 100 ml (1.2/1.0 US/Imp qt)
Overhaul............. 1 200 ml (1.3/1.1 US/Imp qt)
CAUTION
Make sure that the oil filter installed properly. If the fil-
ter is installed improperly, serious engine damage
may result.
CAUTION
Use the new O-ring to prevent oil leakage.
To Next Page
Loading...
