9-5 GEARSHIFTING
INSPECTION
• Inspect the gearshift shaft
1 for bends and damage.
• Inspect the return spring
2 for damage.
• If necessary, replace the defective parts with a new one.
• Inspect the pawls
3, pins
4, springs
5 and gearshift roller
6 for damage.
• If necessary, replace the defective parts with a new one.
INSTALLATION
Install the gearshift in the reverse order of removal. Pay atten-
tion to the following points:
• Apply a small quantity of THREAD LOCK SUPER to the gear-
shift arm stopper
1 and tighten it to the specified torque.
# 99000-32030: THREAD LOCK SUPER “1303”
or equivalent
$ Gearshift arm stopper: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the washer
2, spring
3 and gearshift cam stopper
4.
• Align the pin groove
A with the pin
B when installing the
stopper plate
5.
To Next Page
Loading...
