KICK STARTER 8-5
INSTALLATION
Install the kick starter in the reverse order of removal. Pay atten-
tion to the following points:
• Install the kick starter guide
1.
# Kick starter guide bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the kick starter drive gear
2, washer
3 and snap ring
4 onto the kick starter shaft.
" 09900-06107: Snap ring pliers
• Install the spring guide
5 onto the kick starter shaft.
NOTE:
Align the concave of spring guide
A with kick starter shaft hole
B.
• Install the return spring
6 into the kick starter shaft hole.
• Install the kick starter
7 onto the kick starter shaft.
NOTE:
Be sure to align the punch marks on the kick starter and kick
starter shaft when fitting the kick starter.
CAUTION
Replace the snap ring
4 with a new one.
To Next Page
Loading...
