Suzuki RM-Z450 - Tp Sensor Adjustment

FI SYSTEM DIAGNOSIS 12-18
TP SENSOR ADJUSTMENT
1. Remove the engine mounting upper bracket (LH). ("5-5)
2. Remove the front number plate. ("18-4)
3. Connect a 12 volts battery using the battery lead wire to ser-
vice coupler. ("12-22)
36890-28H00: Battery lead wire (option)
4.Loosen the screw and turn the TP sensor

1.
5.Insert the needle pointed probes to the lead wire coupler.
6. Adjust the TP sensor

1 until the output voltage comes within
the specified value.
7. Then, tighten the screw to fix the TP sensor.
# TP sensor output voltage: 0.58 – 0.62 V
(

+ Y –

- B/Br)
! 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
09930-11950: Torx wrench (T25)
8. Check the engine idle speed. ("2-19)
V