Suzuki RM-Z450 - Clutch Cable Adjuster; Hot Starter Lever Installation

20-24 SERVICING INFORMATION
CLUTCH CABLE ADJUSTER
HOT STARTER LEVER INSTALLATION
Adjustable
range
Do not apply grease to the rubber covers.
Fit the cover positively.
Adjuster
Tur
ur
n to loosen
n to loosen
the clutch cab
the clutch cab
le tension.
le tension.
Turn to loosen
the clutch cable tension.
Tur
ur
n to tighten
n to tighten
the clutch cab
the clutch cab
le tension.
le tension.
Turn to tighten
the clutch cable tension.
When the movement is felt heavier,
clean this and apply grease.
Quick adjuster
1) Pass the hot starter cable
into the lever cover.
2) Connect the hot starter cable
to the master cylinder holder
and hot starter lever.
3) Pass the hot starter lever into the lever cover.
4) Tighten the lower bolt first temporarily
to provide clearance on the upper side
and then tighten both the bolts to the
specified torque.
5) Install the cover of hot starter lever firmly. Be careful not to damage the lever cover when installing.
10 N
.
m
1.0 kgf
.
m
7.0 lb-ft
( )
12 N
.
m
1.2 kgf
.
m
8.5 lb-ft
( )