Suzuki RM-Z450 - Page 230

13-13 FUEL SYSTEM AND THROTTLE BODY
• Install a new O-ring

1.
• Install the IAP sensor as shown.
• Apply thin coat of engine oil to the new O-ring

2 and cushion
seal

3.
• Install the fuel injector by pushing it straight to fuel pipe.
NOTE:
Align the coupler

A of the injector with groove

B of the fuel
pipe.
• Install the fuel injector by pushing it straight to the throttle
body.
• Tighten the fuel pipe mounting screws to the specified torque.
$ Fuel pipe mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
CAUTION
Replace the O-ring

1 with a new one.
CAUTION
Replace the O-ring

2 and cushion seal

3 with new
ones.
CAUTION
Never turn the injector while pushing it.
CAUTION
Never turn the injector while pushing it.