FRONT FORK AND STEERING 18-24
• Tighten the handlebar holder set nuts to the specified torque.
& Handlebar holder set nut: 45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Apply grease to the throttle cable and their hole.
( 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Align the matching mark
D on the handlebars with the throttle
holder matching surface.
• Tighten the screws securely.
NOTE:
Make sure that the cut-line
E of collar
2 to lower side.
• Align the matching mark
F on the handlebars with the master
cylinder matching surface.
• Tighten the lower bolt first temporarily to provide clearance on
the upper side and then tighten both the bolts to the specified
torque. (!20-24)
& Master cylinder holder bolt :
(Lower): 12 N·m (1.2 kgf-m, 8.5 lb-ft)
(Upper): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
To Next Page
Loading...
