FRONT FORK AND STEERING 18-26
• Align the matching mark
B on the handlebars with the clutch
lever holder matching surface.
• Tighten the upper bolt first temporarily to provide clearance
on the lower side and then tighten both the bolts.
• Install the engine stop switch and clamps.
• Install the front number plate and protector.
INSPECTION AFTER INSTALLATION
• Front fork (!2-32)
• Steering (!2-33)
• Wiring harness, cable and hose routing
(!20-19, -21, -24, -25)
• Handlebars set-up (!20-27)
To Next Page
Loading...
