Suzuki RM-Z450 - Page 80

5-4 ENGINE REMOVAL AND INSTALLATION
• Disconnect the magneto lead wire coupler

D and GP switch
coupler

E.
• Remove the clamps.
• Remove the TO sensor bracket bolt and nut.
• Remove the clutch cable bracket bolt

F and disconnect the
clutch cable.
NOTE:
* Mark the clutch cable at which the bracket slit set for correct
reinstallation.
* Loosen the clutch cable adjuster when disconnecting.
• Remove the throttle body. (!13-8)
• Disconnect the spark plug cap.
• Remove the cotter pin

G, washer

H and clip

I.
• Remove the brake pedal spring

J, master cylinder rod pin

K
and brake pedal

L.
• Remove the kick starter lever

M.