Suzuki RM-Z450 - Page 84

5-8 ENGINE REMOVAL AND INSTALLATION
• Install the clip

6, washer

7 and cotter pin

8.
• Install the kick starter lever in the correct position. (!8-7)
$ Kick starter lever bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Fit the projection of the throttle body to the depression of
intake pipe.
• Position the clamps correctly. (!20-22)
• Align the matching mark

H on the clutch cable with slit of the
bracket.
• Tighten the clutch cable bracket bolt to the specified torque.
$ Clutch cable bracket bolt: 6 N·m (0.6 kgf-m, 4.5 lb-ft)
CAUTION
Replace the cotter pin

8 with a new one.