6-5 CYLINDER HEAD, CYLINDER AND PISTON
• Disconnect the ECT sensor coupler
3.
• Remove the cylinder head base bolts
4.
• Loosen the cylinder base bolt
5.
• Remove the cylinder head bolts.
NOTE:
When loosening the cylinder head bolts, loosen each bolt little
by little diagonally.
• Remove the cylinder head
6.
NOTE:
If the cylinder head does not come off easily, lightly tap it using a
plastic hammer.
• Remove the cylinder head gasket
7, dowel pins and cam
chain No.1 guide
8.
CAUTION
Do not drop the cam chain and dowel pins into the
crankcase.
To Next Page
Loading...
