Tadano AML-C User Manual

Chapter D
Chapter DAdjustment mode
174
W301-0411E
D-5 Operation History Erase
This section describes the method to erase the registration contents of operation history information {stored data
of when the crane operation is performed while the load moment ratio is exceeding the set limit value}.
[NOTICE]
Before delivery to users, always repeat erasing the operation as described here three times.
5.1 Operation Procedure
In the adjustment main menu of Fig. 1.3.3, select "History Erase" to display the operation history erase
screen as shown in Fig. 5.1.1.
Under the status shown in Fig. 5.1.1, pressing the <
> key erases the operation history. Then, the erase
confirmation display appears as shown in Fig. 5.1.2.
To go back to the adjustment main menu of Fig. 1.3.3 without erasing the operation history, press the <
>
key while the screen shown in Fig. 5.1.1 is being displayed.
Fig. 5.1.1 Operation history erase display
Fig. 5.1.2 Operation history erase confirmation display

Tadano AML-C Specifications

General

Brand	Tadano
Model	AML-C
Category	Measuring Instruments
Language	English