Technogym Step 700i E - Distance

STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 9.2
9.1.2. DISTANCE
It is possible to choose between EUROPEAN units (kg and km) or IMPERIAL units (pounds and
miles). To change the selection, when the display shows the current setting:
DISTANCE : xxx
Press the +/- GOAL keys to select the desired unit of measurement from the options listed in the
table below:
DISTANCE
KM <default>
MLS
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.3. PRIORITY SETTING
If signals are available from both the chest band and hand sensors, this parameter determines which
is the preferential source for displaying the heart rate value. Obviously, if only one of these two
signals is available, it will be used even if not configured as the preferential heart rate source. To
change the selection, when the display shows the current setting:
PRIORITY : xxx
Press the +/- GOAL keys to select the preferential source from those listed in the table below:
PRIORITY
BAND <default>
HANDS
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.4. MAXIMUM EXCERCISE TIME
It is possible to set a maximum duration for the exercise in minutes, with a value ranging from 1 to
9999. To change the setting, when the display shows the current maximum exercise time:
MAX TIME: xxx
Press the ENTER key to modify the value: when the current parameter value starts to blink, press
the CLEAR key to erase the current value and then use the number keys to enter the desired new
value.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
The default value of this parameter is 9999.