STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 9.4
HR : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
HR
MODIFIABLE <default>
NOT MODIFIABLE
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.9. ENABLE CUSTOM MESSAGES
It is possible to configure whether a custom message is displayed when the machine is in the
standby state. To change the selection, when the display shows the current setting:
CUSTOM MESS. : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
CUSTOM MESS.
YES <default>
NO
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.10. EDIT CUSTOM MESSAGES
It is possible to modify the custom messages; press ENTER to invoke a submenu which displays
the first custom message, then use the +/- effort level keys to move to the other messages. Press the
ENTER key again to begin editing a message, or hold down the CLEAR key for a few seconds to
return to the upper menu level. While editing a message, move the cursor using +/- GOAL, select
the desired letter using the +/- effort level keys and use CLEAR to enter a blank space character.
Press ENTER to save the modified message, or hold down the CLEAR key to cancel and return to
the upper menu level.
9.1.11. CHANGE MESSAGGES LANGUAGES
It is also possible to display the custom standby messages in the language selected with the
preceding parameter. To extend the language setting to the predefined custom standby messages,
when the LED display is showing the current selection:
CHANGE MESS. LANGUAGE
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
To Next Page
Loading...
