Technogym Step 700i E - Service Menu Configuration

STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 9.13
9.3. SERVICE MENU CONFIGURATION
The configuration procedure is invoked when the machine is in standby mode, using a different
procedure for the 500 and 700 models.
• Accessing configuration of 500 models
Simultaneously press the ENTER, ↑, CLEAR keys. The following prompt appears on the display:
ENTER PASSWORD:
To access the procedure, type in the password 2501 which protects against unauthorized access and
press “Enter” to confirm. To enter the password, increase or decrease the displayed value using the
↑ and ↓ keys, or use the +/- GOAL keys to scroll through and modify the individual digits.
At this point there are two options available:
↑ = Tech Config
↓ = Troubleshooting
Press numeric key ↑ to access the menu for configuring technical parameters; the machine display
will begin showing the current configuration, structured as in the diagram below:
• Accessing configuration of 700 models
Simultaneously press the keys 369 for 700 LED models, whereas on 700 Wellness TV models the
keys 0369 must be pressed one after the other. The following prompt appears on the display:
ENTER PASSWORD:
To access the procedure, type in the password 2501 which protects against unauthorized access and
press the “Enter” key to confirm. At this point there are two options available:
1 = Tech Config
2 = Troubleshooting
Press numeric key 1 to access the menu for configuring technical parameters; the machine display
will begin showing the current configuration, structured as in the diagram below: