STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 9.6
9.1.16. LUBRICATED
This parameter tracks the lubrication status of the pedal chains. The default value is “YES”.
Whenever a certain number of floors have been climbed, the machine switches to “awaiting
lubrication” mode, signaled on the display by the message “LUBRICATE THE CHAINS, THEN
PRESS A KEY”, and the parameter value changes to “NO”. When the parameter shows:
LUBRICATED: NO
Press the +/- GOAL number keys to select “YES” then carry out the procedure 10.4. “Lubrication
of the pedals chains”.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.1.17. STANDBY
It is possible, on the Wellness TV models, to set the standby screen. To change the selection, when
the display shows the current setting:
STANDBY : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
STANDBY
TV <default>
STD.DISPLAY
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
To Next Page
Loading...
