Technogym Step 700i E - Default Calories

STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 9.10
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
The default value of this parameter is 15 minutes.
9.2.9. DEFAULT CALORIES
It is possible to set the default calories for an exercise session, with a value ranging from 10 to 999.
To change the setting, when the display shows the current value:
DEFAULT CALORIES xxx
Press the ENTER key to modify the value: The current parameter value starts to blink on the
display; use the ↑ and ↓ keys to increase or decrease the value, or use the +/- GOAL keys to scroll
through and modify the individual digits.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
The default value of this parameter is 300.
9.2.10. DEFAULT DISTANCE
It is possible to set the default distance for an exercise session, with values ranging from 1 to 999.
To change the setting, when the display shows the current value:
DEFAULT DISTANCE KM xxx
Press the ENTER key to modify the value: The current parameter value starts to blink on the
display; use the ↑ and ↓ keys to increase or decrease the value, or use the +/- GOAL keys to scroll
through and modify the individual digits.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
The default value of this parameter is 10.
9.2.11. MODIFIABLE TARGET FREQUENCIES
It is possible to enable or disable modification of the target heart rate during a constant heart rate
exercise. To change the selection, when the display shows the current setting:
HR : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
HR
MODIFIABLE <default>
NON MODIFIABLE
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.