STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 9.12
9.2.15. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the display shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter. If the ENTER key is pressed the display will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
9.2.16. FORMAT P&P KEY
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
display shows:
FORMAT P&P
Press ENTER to confirm. At the end of the formatting procedure, hold down the CLEAR key for a
few seconds to exit. The CLEAR key can be pressed at any time to interrupt the procedure and
revert to standby mode.
9.2.17. LUBRICATED
This parameter tracks the lubrication status of the pedal chains. The default value is “YES”.
Whenever a certain number of floors have been climbed, the machine switches to “awaiting
lubrication” mode, signaled on the display by the message “LUBRICATE THE CHAINS, THEN
PRESS A KEY”, and the parameter value changes to “NO”. When the parameter shows:
LUBRICATED: NO
Press the +/- GOAL number keys to select “YES” then carry out the procedure 10.4. “Lubrication
of the pedals chains”.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
9.2.18. SN
This parameter shows the serial number of the machine.
To Next Page
Loading...
