5 First steps
44 0970 4020 en 01 testo AG
> Click in the
Lower limit field and change the lower limit
value.
If all probes are to have the same limit value, click on
the column title with the right mouse button and then
click on
Apply to all in the context menu. This also
applies for the upper limit value in the next step.
> Click in the Upper limit field and change the upper limit
value.
> Click in the TC type field and enter the type of thermocouple
(Enter:
J, K, S or T) if this information is required for the
instrument.
> Perform step 5 and the following for all other probes until all
required fields are filled.
7. Click on
[Continue >].
- The settings for measuring cycle, the alarm delay and the
alarm issue are shown.
To Next Page
Loading...
