STEERING
6A-2
SPECIFICATIONS
Steering Valve
Relief valve pressure ......................... 1000 psi (69 bar)
Steering circuit flow ....... 5.5 gpm @ 3000 rpm (20 lpm)
Steering Cylinder
Steering cylinder bore ......................... 1.5 in (38.1 mm)
Steering cylinder rod ....................... 0.625 in (15.8 mm)
Steering cylinder stroke........................... 8 in (203 mm)
Steering Axle
Rear wheel toe-in...... 0.625 to 0.125 in (1.6 to 3.2 mm)
Torques
Steering valve cover nuts..22 to 24 ft-lbs (30 to 32 Nm)
Steering cylinder - axle bolt...........................................
........................................70 to 75 ft-lbs (95 to 101 Nm)
Steering cylinder - castle nut.........................................
..........................................40 to 55 ft-lbs (54 to 74 Nm)
Tie rod castle nut...............30 to 35 ft-lbs (40 to 47 Nm)
Front wheel bolt...................................55 ft-lbs (75 Nm)
Rear wheel bolt .................................80 ft-lbs (108 Nm)
To Next Page
Loading...
Need help?
General
