Textron JACOBSEN GP400 - Grass Shield; Bedknife Backing Assembly

8-32 4252490-Rev A
CUTTING UNITS
8
Grass Shield
Removal and Installation
See Figure 8-32.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Remove cutting unit. (See “Cutting Unit” on
page 8-22.)
3. Remove front roller. (See “Front Roller” on
page 8-38.)
Figure 8-32
4. Remove nut (2), lock washer (3), flat washer (4), and
screw (5) from each side of cutting unit.
5. Remove grass shield (1).
Installation Notes
• Install grass shield by reversing the order of removal.
• Adjust the grass shield. (See “Grass Shield
Adjustment” on page 8-18.)
Bedknife Backing Assembly
Removal and Installation
See Figures 8-33 and 8-34.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Remove cutting unit from mower. (See “Cutting Unit”
on page 8-22.)
3. Place cutting unit on a solid work surface.
Figure 8-33
4. Loosen bedknife adjuster screws (1 and 2) on each
side of cutting unit.
Figure 8-34
5. Support bedknife backing assembly (4).
6. Remove bedknife backing mounting screw (3) from
each side of cutting unit.
TN3754
2
1
3
4
5
2
3
4
5
TN0893
1
2
TN3749
3
4
3