3-10 4252490-Rev A
ENGINE
3
Muffler (Diesel)
Removal and Installation
See Figure 3-13.
!
CAUTION
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Raise the hydraulic oil/fuel tank. (See “Raise
Hydraulic Oil/Fuel Tank” on page 9-4.)
3. Allow the engine to cool completely.
Figure 3-13
4. Remove two nuts (5) and muffler clamp (6).
5. Remove three screws (2) and washers (3), gasket
(4), and muffler (1).
6. Inspect the exhaust system for cracks, holes, and
distortion. Replace exhaust gasket.
Installation Notes
• Install muffler by reversing the order of removal.
• Install new gasket (4) during installation.
Coolant Recovery Bottle (Diesel)
Removal and Installation
See Figure 3-14.
!
CAUTION
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
Figure 3-14
2. Disconnect hoses (1 and 2) from coolant recovery
bottle (3).
3. Slide coolant recovery bottle (3) up and remove from
machine.
Installation Note
Install coolant recovery bottle by reversing the order of
removal.
Do not attempt to service the exhaust system
when the engine is hot. Serious personal injury
can occur.
TN3907
5
1
2 3
6
4
Do not attempt to service any part of the coolant
system when the engine is hot. Serious personal
injury can occur.
1
TN3932
2
3
To Next Page
Loading...
