STEERING
4252490-Rev A 7-5
7
Figure 7-5
5. Inspect foam inserts (4 and 5) in the upper (2) and
lower (3) steering column covers. Replace as
needed.
Installation Note
Install steering column covers by reversing the order of
removal.
Control Arm
Removal and Installation
See Figures 7-6 and 7-7.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Remove steering unit. (See “Steering Unit” on
page 7-6.)
Figure 7-6
3. Lower the lift lever (5) and control arm (6) to the
lowest position.
4. Support the control arm (6).
NOTE
Record the position of the left lever relative to the control
arm before removing to ensure correct installation.
5. Remove screw (4), four (two per side) washers (3),
and lift lever (5).
6. Remove lock collar (2) and carriage bolt (1).
TN3691
5
3
2
4
TN3698
1
2
4
3
5
6
To Next Page
Loading...
