3-20 4252490-Rev A
ENGINE
3
Throttle Cable (Gasoline)
Removal and Installation
See Figure 3-34.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Allow the engine to cool completely.
3. Remove throttle lever. (See “Throttle Lever” on
page 9-14.)
Figure 3-34
4. Remove screw (1) and clamp (2), and disengage
throttle cable (2) at the engine.
NOTE
Note routing of throttle cable (2) before removing to
ensure correct installation.
5. Remove throttle cable (2).
Installation Note
Install throttle cable by reversing the order of removal.
Choke Cable (Gasoline)
Removal and Installation
See Figures 3-35 and 3-36.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Allow the engine to cool completely.
Figure 3-35
3. Remove screw (1) and clamp (2), and disengage
choke cable (3) at the engine.
Figure 3-36
4. Loosen jam nut (4) and disengage jam nut from
choke cable (3).
NOTE
Note routing of choke cable (3) before removing to
ensure correct installation.
5. Remove choke cable (3).
Installation Note
Install choke cable by reversing the order of removal.
TN4002
1
3
2
TN4004
1
3
2
TN4003
3
4
To Next Page
Loading...
