Textron JACOBSEN GP400 - Guarantee; Warranty; Service

ELECTRICAL
4252490-Rev A 4-51
4
Battery
Removal and Installation
See Figure 4-36.
!
WARNING
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Open battery cover.
Figure 4-36
!
WARNING
3. Remove nut (6) and screw (7), and disconnect
negative (–) battery cables (4 and 5).
4. Remove nut (6) and screw (7), and disconnect
positive (+) battery cables (8 and 9).
5. Remove nuts (1), screws (2), and retainer brackets
(3) from battery tray.
NOTICE
6. Remove battery (10).
Installation Note
Install battery by reversing the order of removal.
Alternator
Removal and Installation
See Figure 4-37.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
3. Raise hydraulic oil/fuel tank. (See “Raise Hydraulic
Oil/Fuel Tank” on page 9-4.)
Figure 4-37
NOTE
Label all wires before disconnecting to ensure correct
installation.
4. Disconnect wire connectors (4 and 5).
5. Support alternator (6).
6. Remove screw (1), lock washer (2), and flat washer
(3).
7. Remove screw (7), flat washers (8 and 9), lock
washer (10), and nut (11).
8. Remove alternator.
• Battery posts, terminals, and related
accessories contain lead and lead
compounds. Wash your hands after handling.
• Always wear eye protection when servicing
battery.
Always disconnect the negative terminal first and
positive terminal last. Connect positive terminal
first and negative terminal last. Use care when
testing live circuits to prevent arcing. Arcing
could result in death or serious injury.
TN3874
6
2
7
6 7
1
21
4 5
8 9
3
3
10
Never place used batteries in the garbage.
Dispose of used batteries in accordance with all
applicable regulations.
4
TN3935
3
7 8
5
21
9 10 11
6