Temperature/ Humidity Module (with Dual External Sensors)
20 Administrator Guide v 2.2 Thermo Scientific Smart-Vue
®
Wireless Monitoring Solution
3.4 Placing the Sensor
and Smart-Vue Module
1. Connect the sensor and wireless module by joining the connectors.
Figure 8. Align and press firmly to join connectors
2. Mount the Smart-Vue module in the desired location using the provided
plastic holder, which you may mount using a magnet or Velcro® tape.
Choose the method that works best for your location and place the
Smart-Vue module as described earlier in “How to place your Smart-Vue
module for best performance” refer to Section 1.6.
3. Use the provided plastic cable holders to attach or coil the excess cable
neatly.
CAUTION: When routing the cable for the Smart-Vue sensor, avoid direct
contact with or close proximity placement of the sensor cabling with any
high voltage wiring. Cabling should be placed with no less than a minimum
of 5 cm (2 inches) distance from high voltage components. Also, avoid
running the sensor cable in parallel with high voltage wiring.
For all other manufacturers’ equipment, contact the manufacturer of the
instrument for instructions regarding proper placement of the sensor.
3.5 Where to find More
Information
The Smart-Vue Software User Manual provides detailed information on
module and system configuration. You may click on Help User manual
( ) to open the software user manual directly from within the Smart-Vue
Client software.
Insert sensor connector Rotate ring to lock into place
To Next Page
Loading...
Need help?
General