Power-over- Ethernet (POE) TCP/IP Receiver
70 Administrator Guide v 2.2 Thermo Scientific Smart-Vue
®
Wireless Monitoring Solution
4. Enter the IP Address, Default Gateway, Hostname, Domain, DHCP
Client ID, Primary DNS, Secondary DNS fields to match your
network. This information is dependent on having an available static
address. Contact your system administrator if necessary.
CAUTION: If you intend to use a host name to connect to your server,
you must fill in both the Hostname and DNS Server fields here.
By default, the Network Mask is set to 255.255.255.0.
5. Important: Click on Submit to save your changes.
13.8 Configuring the
Emulated Serial Port
1. In the left-hand menu bar, click on Line Line 1 Configuration:
Figure 40. Emulated serial port configuration
2. Set these values as follows:
State = Enabled
Protocol = Tunnel
Baud Rate = 9600
Data Bits = 8
Flow Control and Parity = None
Stop Bits = 1
To Next Page
Loading...
Need help?
General