Power-over- Ethernet (POE) TCP/IP Receiver
Thermo Scientific Smart-Vue
®
Wireless Monitoring Solution Administrator Guide v 2.2 73
1. In the left-hand menu bar, click on DNS:
Figure 42. Checking DNS configuration
2. Check to make sure that the information in the DNS Cache zone is
correct, notably that the IP address and Domain Name correspond to
the Smart-Vue Server computer.
CAUTION: You do not need to make any changes to the other sections in
the configuration application.
If this information is correct, then the PoE network receiver is ready to use
in your Smart-Vue Monitoring System.
13.11 Where to Find
More Information
This topic was covered earlier in this document, in section 12.6 Configuring
network receivers in Smart-Vue Client. For more details, please see the
Smart-Vue Server /Smart-Vue Client software User Manual. You may click on
Help User manual ( ) to open it directly from within the Smart-Vue
Client software.
To Next Page
Loading...
Need help?
General