TCP/IP dry contact device
90 Administrator Guide v 2.2 Thermo Scientific Smart-Vue
®
Wireless Monitoring Solution
3. In the Alert test window, select the receiver or sensor you wish to check.
Figure 50. Select the Sensor and Type of Test
4. From the Select remote to be tested pick-list to choose the type of alarm
you wish to test (e.g., Low limit exceeded).
5. Click on Te s t
Close.
6. Click on the Alarms button in the lower left-hand corner of the screen
to view the alarms zone. Within a few seconds, the test alarm will appear
in the alarms zone.
Figure 51. Select the Sensor and Type of Test
To Next Page
Loading...
