- 29 -
⑤ Integ Delay Time : Set the integral delay time.
This menu is indicated when set the Integ Delay ON/OFF to ON
(refer to ④ Integ Delay ON/OFF).
☞
‘3.4.1 Delay Time Setting’
⑥ Single or Auto Run : Set the measurement method.
☞
‘3.5 Single or Auto Run’
⑦ AverageMeasON/OFF : Set whether to use average measurement function or not.
☞
‘3.14 Measurement Averaging’
⑧ Average time : Set the measuring times.
This menu is indicated when set the AverageMeasON/OFF to ON.
(refer to ⑦ AverageMeasON/OFF)
☞
‘3.14.1 Averaging Count’
⑨ Measurment speed : Set the Measuring speed.
☞
‘3.6 Measuring Speed’
⑩ High Speed Cal. : Perform the calibration before conducting measurement in High
Speed mode.
☞
‘3.6.1 High Speed Calibration’
⑪ FIX FREQ Setting :Set the frequency value and inner-filter type in the FIX FREQ mode.
☞
‘3.3.4 FIX FREQ Mode’
(2) FACTOR: For the correction factor
① Factor ON/OFF : Set whether to use a correction factor or not.
☞
‘3.11 Using a Correction Factor’
② X Y Z factor : Set the a correction factor for tristimulus values X, Y, Z.
This menu is indicated when set the Factor (XYZ) to ON.
☞
‘3.12 Displaying and Changing the Correction Factor’
③ CIE Type Select : Set the CIE Color Matching Function. (Visual field)
☞
‘3.13 CIE Color Matching Function (Visual field)’
④ Color Match Type : Set the CIE Color Matching Function. (Type)
☞
‘3.14 CIE Color Matching Function (Type)’
⑤ Direct-Conn Factor : Perform the Direct Correction function for reducing instrumental
error between a plurality of instruments.
☞
‘2.5.5 Reducing instrumental error between a plurality of instruments’
To Next Page
Loading...
Need help?
General
