Topcon TRK-1P - Setting for Printing the Measurement Result

45
PREPARATIONS
SETTING THE MEASUREMENT MODE AFTER POWERING ON
It is possible to set the measurement mode after powering on. Factory setting, it is set to "R/K-
T/P" (REF/KRT, TONO/PACHO continuous measurement).
1 Select "INITIAL SET" of the INITIAL MENU screen and get the INITIAL SET screen.
2 Press of the Set item change button and bring the cursor to " MEASURING MODE."
3 Press or of the Set value change button and select the desired measurement
mode.
"R/K-T/P" : REF/KRT, TONO/PACHO continuous measurement mode
"R/K" :REF/KRT measurement mode
"T/P" :TONO/PACHO measurement mode
4 Press the Set item change button to move the cursor to the next item.
When R/K-T/P is set, measurement starts from the REF/KRT mode.