Toshiba B-EX4 SERIES - Page 115

5. SYSTEM MODE EO18-33027
5.3 DIAG
5-19
RETRY MIN AGC
AGC threshold lower limit for
retry
0 to15
TAG CHECK
RFID error tag detection
OFF
Detection is disabled.
ON (ID)
RFID error tag
detection for ID area
data
ON (ACCESS
PASSWORD)
When PASS is
selected, the following
settings are
subsequently
displayed:
Password setting to
protect error tag
detection
ON: Enabled
OFF: Disabled
Automatic unlock
function setting
ON: Enabled
OFF: Disabled
CALIB. MODE (*2)
RFID calibration mode
OFF
Disabled
ON
Enabled
CALIB. AGC (*2)
Optimum AGC value
obta
ined through RFID
calibration
0 to 15
CALIB. POSITION (*2)
Distance to the optimum
read/write position obtained
through RFID calibration
-999.9mm to
+999.9mm
ANTENNA POSITION (*2)
Position of the RF antenna
and the wave director
FRONT
Front
CENTER
Center
REAR
Rear
MULTI WRITE
Hibiki tag multi-word write
ON
Enabled
OFF
Disabled
HEADUP ACTION (*3)
Head up action during
reverse feed
MODE1
The print head is raised
in accordance with the
ribbon save and the
head up settings.
MODE2
The print head is raised
during very reverse
feed.
WRITE OK TAGS
Count of RFID success label
write issue
0 to 9999999
VOID PRINT TAGS
Count of RFID failure label
write issue
0 to 9999999
*1: Supported from the printer firmware version of C1.0I for the B-EX4T1-G/T-QM/CN, C1.0F for the B-EX4T2-G/T-QM/CN, and V2.1 for the
B-EX4T1-TS25-R.
*2: Supported by the B-EX4T1-G/T-QM/CN C1.4 or later.
*3: Supported from the firmware version of V2.2 for the B-EX4T1-TS25-R.
<< RTC >>
Item
Description
Printed value
BATTERY CHECK
Battery check
ON
Enabled
OFF
Disabled
RENEWAL
Time update timing
BATCH
per batch
PAGE
per page