Toshiba B-EX4 SERIES - Log Save Operation Example; Lcd Messages and Led Indications

6. ON LINE MODE EO18-33027
6. 11 LCD MESSAGES AND LED INCATIONS
6-25
6.10.5 Log Save Operation Example
[Online mode]
[Pause mode]
1. Normal condition
↓ Hold down the [ENTER] key for 3 seconds.
[Log save mode]
Log files are saved.
(Nothing happens to the
LCD.)
↓ The log file has been saved.
After saving the log file,
the printer restarts.
After saving the log file
, the printer automatically restarts.
Release the [ENTER] key at this timing.
6.11 LCD MESSAGES AND LED INDICATIONS
No
LCD Message
2
nd
line
（English）
LED
indications
Printer status
Restoration by
the [RESTART]
key
Yes/No
Acceptance of
Status Request
and Reset
Command
Yes/No
ON
LINE
ERROR
1 ONLINE

●
In the online mode
---
Yes

●
In the online mode
(Communicating)
--- Yes
 
In the online mode with a ribbon
near end detected (Note 3)
--- Yes
2 HEAD OPEN
● ●
A feed or an issue was attempted
with the head opened.
--- Yes
● 
A feed or an issue was attempted
with the head opened in a ribbon
near end state.
--- Yes
3 PAUSE
●
●
In a pause state
Yes
Yes
●

In a pause state with a ribbon
near end detected (Note 3)
Yes Yes
4 COMMS ERROR ● 
A parity error or framing error has
occurred during communication
by RS-232C.
Yes Yes
5 PAPER JAM ●

A paper jam occurred during
paper feed.
Paper was not set properly.
Label actually used and the
selected media sensor type do
not match.
The media sen
sor position does
not align with the black mark
position.
The actual media size and the
specified media length do not
match.
The level of media sensor is not
Yes Yes
B-EX Series
Initializing...