5. SYSTEM MODE EO18-33027
5.2 OVERVIEW
5-2
In System Mode, the keys function as described below.
Display top menu without saving setting.
Display upper menu without saving setting.
[UP] [FEED]
Move cursor up. Not move when cursor in the upset
position.
[DOWN] [RESTART] Move cursor down. Not move when cursor is in the lowest
5.2 OVERVIEW
System Mode consists of nine main menus:
Perform self diagnostics test and print result, print head failure test.
Set the parameter for each function of printer.
Adjust printer mechanism position and sensor.
Perform slant line printing, character printing and barcode printing.
SENSOR ADJUST
Display outer temaprature and head temparature and adjust each paper
sensor.
Clear maintenance counter and parameter.
Set interface setting like network, USB, RS232C and parallel.
Set the function of basic program when it is loaded printer.
Set date&time and time which is refrected for printing.
Same as BASIC. It is not diplayed if the model is JA.
USB MEMORY Load the firmware which is stored in USB memory and save information to
To Next Page
Loading...
Need help?
General
