5. SYSTEM MODE EO18-33027
5.1 OPERATION PANEL
5-1
5. SYSTEM MODE
The system mode can be entered by the following procedure from printer power off condition.
• Press [FEED] key and [PAUSE] key at the same time
• Press [MODE] Key
In this mode, the printer self-test operation and parameter setting operation are performed.
When displaying top menu, main firmware version is shown at right side of title.
The language displayed on the panel is Japanese if Japanese is selected by language setting and English if
English, German, French, Dutch, Spanish, Italian or Portuguese is selected.
5.1 OPERATION PANEL
The figure below illustrates the Operation Panel and key functions.
The figure below illustrates the Operation Panel and key functions.
The LCD Message Display shows messages in alphanumeric characters and symbols to indicate the
printer’s status. Up to 16 characters in 2 lines can be displayed.
There are three LEDs on the Operation Panel.
The printer is turned on.
The printer is ready to print.
Any error occurs with the printer.
Graphic LCD
RIGHT key
To Next Page
Loading...
Need help?
General
