Toshiba B-EX4 SERIES - Page 222

6. ON LINE MODE EO18-33027
6. 11 LCD MESSAGES AND LED INCATIONS
6-26
suitable for the actual media.
The gap of label cannot be
detected due to pre-printing.
6 CUTTER ERROR ● 
A paper jam occurred in the
cutter.
The cutter did not move from the
home position.
The cutter cover was open.
Yes Yes
7 NO PAPER ● 
The media has run out.
The media has not been set.
Media sensor level is not suitable
for the paper used.
Yes Yes
8
NO RIBBON
●

The ribbon has run out.
Yes
Yes
9 HEAD OPEN ●

A feed or an issue was attempted
with the head opened.
(Except media feed caused by
the [FEED] key or Expansion I/O)
Yes Yes
10 HEAD ERROR ● 
A broken dot error has occurred
in the thermal head.
The error has occurred in the
head driver.
Yes Yes
11
EXCESS HEAD
TEMP
● 
The thermal head temperature
has become excessively high.
No Yes
12 RIBBON ERROR ● 
An abnormal condition occurred
with the sensor for determining
the torque of the ribbon motor.
A ribbon jam occurred.
The ribbon has been torn.
The ribbon has not been set.
Yes Yes
13 REWIND FULL ● 
An overflow error has occurred in
the rewinder unit.
Yes Yes
14
SAVING
####KB/&&&&KB
or
SAVING %,%%%.%%
%KB
 ●
Writable characters or PC
command save mode.
--- Yes
15
FORMAT
####KB/&&&&KB
or
FORMAT %,%%%.%%
%KB

●
Initializing the storage area.
--- Yes
16 NOW LOADING…  ●
Downloading TrueType font or
BASIC program
--- Yes
17
MEMORY WRITE
ERR.
●

An error has occurred while
writing data into
the memory for
storage. (USB memory, flash
ROM on the CPU board)
No Yes
18 FORMAT ERROR ● 
An erase error has occurred while
formatting the memory for storage
(USB memory, flash Rom on the
CPU board)
No Yes
19 MEMORY FULL ● 
Saving failed because of the
insufficient capacity of the
memory for storage (USB
memory, flash ROM on the CPU
board)
No Yes
20
SYNTAX ERROR
●

A command error has occurred
Yes
Yes