Toshiba B-EX4 SERIES - 5.11 RFID Module Setting

5. SYSTEM MODE EO18-33027
5.11 RFID Module Setting
5-86
5.11 RFID Module Setting
 Outline of the RFID Module Setting
In the RFID Module Setting mode, you can set various parameters related to the RFID module.
It is necessary to set these parameters before operating the RFID module.
If a read or write error occurs frequently, adjust the values for the parameters.
The RFID Module Setting menu contains the following:
MENU ITEM
SYSTEM MODE
<10>RFID
TEST
ID READ
MODULE
MODULE TYPE
COUNTRY
TAG
RF CHANNEL
RETRY
ADJ RETRY POSITION
ISSUE RETRY LABELS
READ RETRY
WRITE RETRY
UHF SETTING
POWER LEVEL
Q VALUE
AGC THRESHOLD
WRITE AGC THRESHOLD
WRITE RETRY MIN AGC
CALIB. MODE *1
CALIB. AGC *1
CALIB. POSITION *1
ANTENNA POSITION *1
Other
TAG CHECK
MULTI WRITE
HEADUP ACTION *2
CARRIER SENSE
*1: Supported by the B-EX4T1-G/T-QM/CN C1.4 or later.
*2: Supported by the B-EX4T1-TS25-R V2.2 or later.